The plumbing is well into the fitting stage with only the Hot Water storage system to be completed, The Grey water Tank & plumbing is finished & in use, the tank is a bladder type unit of 270 litres which sits on the Chassis over the rear axle system, there is a dump point inside the right rear mud guard.
The water supply system consists of 1 bladder of 380 litres for non-potable water & 1 poly tank of 420 litres for Potable water, these systems can be bypassed if town supply is in use to supply all taps without mixing or filling either tanks. A 2nd hose fitting is available to allow filling of either of these tanks individually when needed, there is also a filling point for the Non-potable tank to allow filling from a can.
The system runs 2 separate pumps, the hot water is supplied from the Non-potable tank only. All of the Main outlets are supplied by the Non-potable system the only exception being the Main Kitchen Flick mixer which has a selection tap for the Cold side which allows the use of Potable or Non-potable water from this unit.
There is also a Filtered water system which is supplied from the potable water tank, this system has 1 outlet at the Kitchen sink & 1 at the Vanity unit in the bathroom. All hot water for the Vanity unit & the shower runs through a Temperature control unit mounted on the Vanity unit.
View from left hand wheel arch at Plumbing for Gray water.
Don’t want to have to do anymore work under here, needed to be an octopus after the floor went back in!
Drain point for the Gray water system, the silver pipe behind is the exhaust pipe for the diesel hot water system.
View of Gray water system prior to installation of Shower base & new floor over rear suspension.
Marine ply container for the Gray water bladder, this unit was all treated with Funga-shield & sealed.
The flexible hose from 270 litre Bladder to main plumbing pipe.
Drainage plumbing prior to installation of the Vanity unit.
The 2 water inlets, the town water is currently connected the small white door on the left has the Hose & Can filler access. The larger hatch is for access to the Toilet Cassette, the large white door lower in the mud guard is for servicing the Air Filter on the Diesel Hot water unit.
Water supply system, the filtration system directly above the 2 pumps & the timber containment walls for the Non-potable water bladder above & left. The rear end of the Poly tank for the potable water is visible to the right, both of these tanks sit over the chassis rails between the RH & LH Bins.
3 way tap for selecting tank for filling.
The 2 taps for isolating the tanks from the mains connection if required can be seen on the timber panel. the clear hose is for filling the Non-potable tank from can or pumped from a creek.
The small black tap on the sink between the flick mixer & the filtered water outlet is for selecting Potable or Non-potable water for the flick mixer. The fitting on the very left is a soap dispenser pump.
chris95csepel 