The Final seating arrangements are to be the forward facing Dinette seat replaced with a Coach seat which has the Seat belts built in, We have purchased a new ISRI 6860 Air seat for the front passenger,this will meet registration requirements for the 4 seat compliancing.

The front passenger seat has been fitted with a turntable & Arm rests thus allowing it to be used as a Lounge & Computer chair when not in Transit, it was recovered in a material to match the 2 seat lounge unit.

The old drivers seat has now been updated to a ISRI 6860 suspension seat to match the passenger seat, however we have left it with the original covering. 1 of the better of the old bench seats from the original lay out has been used for the Dinette at present but both it & the Coach seat are yet to be recovered with our selection of fabric.

The Dinette table folds back to the wall when in transit allowing more room for these passengers when & if on board.

The Driver now gets a new ISRI 6860 seat as well.

The drivers new seat in place ready for action.

The Passengers Throne, I spoil her too much.

Front view, seat has turntable which allows 360 deg. rotation.

The front Passenger seat in position beside the stairs from the driving platform. It was finally mounted slightly forward & to the left of this position to allow the Main lounge to be reclined without interference once the Passenger seat was rotated.

The Dinette table extended, i have used this timber for all bench & table tops throughout the RV.

Both sets of seats are to be recovered with a change of Material to better suit the colors in the Vehicle.

I have replaced the forward facing seats with a Coach seat, these incorporate Seat belts which meets the transit seating requirements.