The Cook-Top has now been fitted to the Kitchen Bench, all of the wiring & plumbing for the LPG has been completed, inspected & the Gas Compliance certificate has been issued ready for vehicle registration.

Thetford 3 burner Cook-Top to be fitted.

This unit is more user friendly than the original House-Hold unit i purchased?

Position for final fitment on the short end of the bench beside the Pantry.

Aluminum composite splash backs work well with the Laminated bench top & Cook-Top.

Cook-Top fitted into the Bench & Range hood fitted above.

The LPG system on the RV will only be required for the Cook-top & Barbeque units as no other Equipment requires LPG, this should allow a reasonable life out of the Gas available.

I have found a convenient place for the 2 LPG cylinders directly in front of the current Radiator Air inlet, this area can be accessed through the door for the Radiator access & will allow the use of a slide out Rack for the cylinders. This also places the LPG supply no more than 4 metres from the connection point for the Hot plates & directly opposite the Bayonet fitting in the rear most Bin on the other side of the Vehicle.

The most suitable area for the Gas storage required the modification to the Air Reservoir height for the vehicles Air Suspension.  The adjustment of the Air reservoir height has bee made & a slide system for the LPG bottles has been made & fitted.

The Position for the LPG storage selected as the most suitable. This is the Area for the Dryer & 1 of the Air tanks for the Vehicle Suspension.

Once the Tank was lowered the rack fitted nicely over the top!

The rack slides out easily for bottle replacement.